WEEK 9: Engine Swap finished ready for WOF and pickup, battery design module cut out, thermistors and LCD's

This week I pretty much finished the entire engine swap and figured out the rest of the wiring to get the car operating as normal.

I wired the power steering back in as well as the cooling fan in the side and then soldered in the ignition jumpers I made earlier in properly.

I then got the car tided up and gave it a good wash so it is now ready for a WOF and pickup maybe next weekend!

'

After taking it in for a WOF on Tuesday morning of week 10, it is now ready to drive on the road and roll once again!





I also milled out my battery module design out of plywood and it turned out great, I want to implement a temperature sensor in each one as well.

And I cut out test flanges for the stator motor mounts out of plywood. I plan for these to be made properly out of either thick aluminium or steel.